Search results
Results from the WOW.Com Content Network
High grade and ultra high grade anthracite are harder than standard grade anthracite, and have a higher relative density. An example of a chemical formula for high-grade anthracite would be C 240 H 90 O 4 NS, [25] representing 94% carbon. [26] UHG anthracite typically has a minimum carbon content of 95%.
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .
This is tested in a calibrated mill, containing four blades of known mass. The coal is agitated in the mill for 12,000 revolutions at a rate of 1,500 revolutions per minute.(I.E 1500 revolution for 8 min.) The abrasion index is determined by measuring the loss of mass of the four metal blades.
Though bituminous coal varies in its chemical composition, a typical composition is about 84.4% carbon, 5.4% hydrogen, 6.7% oxygen, 1.7% nitrogen, and 1.8% sulfur, on a weight basis. [11] Its bank density (the density of a coal seam prior to breaking up during mining) is about 1346 kg/m 3 (84 lb/ft 3) while the bulk density of extracted coal is ...
50 g of air dried coal featuring a grain size in the range between 0.6 and 1.18 mm are filled into the sample mill and a weight is put on the mill's grinding stone. After 60 rounds the grinded coal is put on a sampling sieve. Factor D equals the fraction of the coal passing through the sieve of 74 μm corresponding to 200 mesh.
The heat content of sub-bituminous coals range from 8300 to 11,500 BTu/lb or 19.3 to 26.7 M J/kg. Their relatively low density and high water content renders some types of sub-bituminous coals susceptible to spontaneous combustion if not packed densely during storage in order to exclude free air flow.
The Wobbe index is expressed in MJ/Nm³ (where 'Nm³' indicates'm³ in Normal conditions), or sometimes in BTU/scf.In the case of natural gas (molar mass 17 g/mol), the typical heating value is around 39 MJ/Nm³ (1,050 BTU/scf) and the specific gravity is approximately 0.59, giving a typical Wobbe index of 51 MJ/Nm³ (1,367 BTU/scf).
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]