Search results
Results from the WOW.Com Content Network
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
The final rafter fits on top of the previous rafter and under the very first one. The rafters are then tied before the temporary support is removed. The structure is most effective at lower pitches where there is minimal spreading force exerted at the ringbeam, most being transferred directly downward.
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Gable (ridged, dual-pitched, peaked, saddle, pack-saddle, saddleback, [5] span roof [6]): A simple roof design shaped like an inverted V. Cross gabled: The result of joining two or more gabled roof sections together, forming a T or L shape for the simplest forms, or any number of more complex shapes.
The simplest form of roof framing is a common rafter roof. This roof framing has nothing but rafters and a tie beam at the bottoms of the rafters. The next step in the development of roof framing was to add a collar, called a collar beam roof. Collar beam roofs are suitable for spans up to around (4.5 meters). [5]