enow.com Web Search

  1. Ads

    related to: 4 ohms amplifier 8 speakers

Search results

  1. Results from the WOW.Com Content Network
  2. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    If a home hi-fi amplifier specifies 8 ohm or greater loads, care should be taken that loudspeakers with a lower impedance are not used, lest the amplifier be required to produce more current than it was designed to handle. Using a 4 ohm loudspeaker system on an amplifier specifying 8 ohms or greater could lead to amplifier failure.

  3. NAD 3020 - Wikipedia

    en.wikipedia.org/wiki/NAD_3020

    The amplifier's main appeal was its inherent musicality, its ability to drive difficult speaker loads, and to allow audiophile grade source components to excel. [2] [3] Launching the product in the US at the Consumer Electronics Show, the company wired up a battery of loudspeakers in a way which presented an impedance of 1.1 ohm, and the ...

  4. Bass amplifier - Wikipedia

    en.wikipedia.org/wiki/Bass_amplifier

    The power handling capabilities of a speaker cabinet or individual speaker are always given in relation to a specific impedance (a measure of electrical resistance); the most common impedance ratings in bass speaker systems are 8 ohms and 4 ohms, although some equipment is rated down to 2 ohms or even more rarely to 1 ohm.

  5. Fender Bassman - Wikipedia

    en.wikipedia.org/wiki/Fender_Bassman

    The output was 50 watts at 8 ohms into a single 12 inch speaker, with a "Tone Ring" baffle in the speaker cabinet. In early 1961, model 6G6-A was introduced with a solid state rectifier replacing the GZ34, and two 12" speakers with a conventional baffle in a slightly larger cabinet (wired in parallel) with a 4-ohm output.

  6. Nikko TRM-800 - Wikipedia

    en.wikipedia.org/wiki/Nikko_TRM-800

    At 8 ohms, the amp could put out 65 Watts per channel RMS (90 Watts per channel RMS at 4 ohms [1]), delivering superb high fidelity sound with exceptional tone quality. Unlike many amps of this time, however, the TRM-800 was stable at lower impedances than 8 ohms; down to 4 ohms. [1]

  7. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal voltages. The result will be very weak sound from the speaker and possibly a damaged line out circuit.

  1. Ads

    related to: 4 ohms amplifier 8 speakers