Ads
related to: 4 ohm speaker performance
Search results
Results from the WOW.Com Content Network
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
This 2-way, 4-ohm, design was a physically much smaller product – measuring 425 × 332 × 244 mm (16.7 × 13.1 × 9.6 in) – that required tall speaker stands. Launched in 1978, it was Linn's entry-level loudspeaker until the Kan (a non-isobaric bookshelf speaker using the same Linn D20-LP-1 and KEF B110 drive units as its big brother) was ...
The 2.6, 2.7i, MG-III, 3.7, Tympani IV, 20.7 and 30.7 all include Magnepan's ribbon driver and thus produce sound up to 40 kHz. The other speakers do not include a true ribbon and therefore produce sound only up to about 18–25 kHz. All Magnepans are 4-ohm speakers, with sensitivity of 86 dB at 500 Hz, 2.83 V.
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal voltages. The result will be very weak sound from the speaker and possibly a damaged line out circuit.
Ads
related to: 4 ohm speaker performance