Search results
Results from the WOW.Com Content Network
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
A typical 5 mm shelf stud may measure 15-16 mm long, and has a thin flange of about 7 mm diameter halfway at its length. Distance of the front row of holes to the front edge: 37 mm; The system includes matching fittings, with which furniture sides can be secured to floors, walls, and adjacent cabinets.
A characteristic of the eastern school is close studding which is a half-timbering style of many studs spaced about the width of the studs apart (for example six-inch studs spaced six inches apart) until the middle of the 16th century and sometimes wider spacing after that time. Close studding was an elite style found mostly on expensive buildings.
In construction, a dwang Scotland and New Zealand, [1] [2] [3] nogging piece, nogging, noggin or nog (all derived from brick nog) [4] [5] England and Australia, or blocking North America, is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
The base plate or floor plate is the bottom attachment point for the wall studs. Using a top plate and a bottom plate, a wall can be constructed while it lies on its side, allowing for end-nailing of the studs between two plates, and then the finished wall can be tipped up vertically into place atop the wall sill; this not only improves ...
Timber roof truss example. The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs.In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam.