Search results
Results from the WOW.Com Content Network
The quarter of a yard (9 inches) was known as the "quarter" without further qualification, while the sixteenth of a yard (2.25 inches) was called a nail. [62] The eighth of a yard (4.5 inches) was sometimes called a finger, [63] but was more commonly referred to simply as an eighth of a yard, while the half-yard (18 inches) was called "half a ...
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output. For example, if the output is "in hand", the inches value is rounded independently from the hands value.
If using the imperial units yards for distance and inches for target size, one has to multiply by a factor of 1000 ⁄ 36 ≈ 27.78, since there are 36 inches in one yard. distance in yards = target in inches angle in mrad × 27.78 {\displaystyle {\text{distance in yards}}={\frac {\text{target in inches}}{\text{angle in mrad}}}\times 27.78}
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [5] Common imperial units and U.S. customary units of length include: [6] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use.From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13]
The Compositio redefined the yard, foot, inch, and barleycorn to 10 ⁄ 11 of their previous value. [dubious – discuss] However, it retained the Anglo-Saxon rod of 15 x 11 ⁄ 10 feet (5.03 metres) and the acre of 4 × 40 square rods. Thus, the rod went from 5 old yards to 5 + 1 ⁄ 2 new yards, or 15 old feet to 16 + 1 ⁄ 2 new feet. The ...
The main units of length (inch, foot, yard and international mile) were the same in the US, though the US rarely uses some of the intermediate units today, such as the (surveyor's) chain (22 yards) and the furlong (220 yards). At one time, the definition of the nautical mile was based on the surface area of the Clarke ellipsoid.
End of the standard yard of 1855 showing the gold plugs which bore the markings for the standard yard. The standard yard and [Troy] pound were lost in 1834 when a fire partially destroyed the Palace of Westminster. Following a report published in 1841 by a commission, a new standard yard and pound were manufactured using the best available ...