Search results
Results from the WOW.Com Content Network
The .45 Auto Rim, also known as 11.5x23mmR, is a rimmed cartridge specifically designed to be fired in revolvers originally chambered for the .45 ACP cartridge.. The Peters Cartridge Company developed the cartridge in 1920 for use in the M1917 revolver, large numbers of which had become available as surplus following the end of World War I. [3]
.45 ACP South Africa: CZ 97B: Česká zbrojovka Uherský Brod.45 ACP Czech Republic: 1997 DOSS SH.A.R. Psh-45 DOSS SH.A.R. .45 ACP Ukraine: FitzGerald Special: Colt USA .45 ACP United States: 1926 FN FNP: FNH USA: 9×19mm Parabellum.40 S&W.45 ACP.357 SIG Belgium United States: 2006 FN FNX: FNH USA: 9×19mm Parabellum.40 S&W.45 ACP Belgium ...
[17] [18] [19] While high capacity firearms are available in .45 ACP, the greater length and diameter of the .45 ACP means that the grip of the pistol must be longer and wider than the grip of a comparable pistol of a smaller caliber, such as 9×19mm Parabellum; this increase in grip size can make the pistol difficult to use for shooters with ...
It is essentially a .45 ACP case, necked down to .357, resulting in a cartridge similar in form to the earlier 7.65×21mm Parabellum and 7.63×25mm Mauser cartridges. It was created to be a low recoil target cartridge that would function reliably with multiple bullet types, FMJ to cast lead wadcutters without the feeding problems that straight walled pistol rounds sometimes exhibit. [2]
The Colt M1917 Revolver was essentially the same as the M1909, but with a cylinder bored to take the .45 ACP cartridge and the half-moon clips to hold the rimless cartridges in position. In early Colt production revolvers, attempting to fire the .45 ACP without the half-moon clips was unreliable at best, as the cartridge could slip forward into ...
The cartridge uses the same rim size as the .45 ACP and a .45 shell holder can be used for reloading. This new brass is made by Starline Brass and is slightly shorter than a standard .45 ACP. The magazine well in the grip frame has thinner walls than a standard M1911 to accommodate the .50 GI's wider magazine, and the frame feed ramp is ...
Necking a .45 ACP to .40 caliber was nothing new. Before the public debut of the .40 S&W, Charles Petty, a well-known and respected writer, had already ventured into the bottleneck arena. His cartridge, called the "10mm Centaur", was based on a .45 ACP case necked to .40 caliber using 10 mm dies.
The Colt Dragoon Revolver had a comparatively shorter cylinder (thus preventing overloading the cylinder) and held up to 50 grains of powder, whereas the Walker had used up to 60 grains of powder. The Dragoon Revolver had a shorter barrel at 7.5 inches (190 mm) (and on some later revolvers, 8 inches [200 mm]) as compared to the 9-inch (230 mm ...