enow.com Web Search

  1. Ads

    related to: 3.5 header collector gasket sizes

Search results

  1. Results from the WOW.Com Content Network
  2. GM 10.5-inch 14-bolt differential - Wikipedia

    en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

    There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.

  3. Chevrolet small-block engine (first- and second-generation)

    en.wikipedia.org/wiki/Chevrolet_small-block...

    [citation needed] In 1968, the last year for factory headers, they had 1.75 in (44.5 mm) primaries x 3 in (76.2 mm) collectors. A stock 1968 Z/28 with the close-ratio transmission, optional transistorized-ignition and 4.88 gear, fitted with little more than the factory cowl plenum cold-air hood induction and headers, was capable of running 12.9 ...

  4. Subaru EJ engine - Wikipedia

    en.wikipedia.org/wiki/Subaru_EJ_engine

    The EJ251 commonly experienced head gasket failures in the form of interior channel breaches or exterior fluid leaks due to the use of a single layer coated gasket, vs the Multi-Layer Steel (MLS) gasket used in later models. Intake air mass is calculated by the use of a MAP sensor and Intake Air Temp Sensor, unlike the EJ253 which uses a MAF ...

  5. Engine displacement - Wikipedia

    en.wikipedia.org/wiki/Engine_displacement

    In Japan, the engine displacement is one of the factors (along with overall vehicle size and power output) used to determine the vehicle size class and therefore the cost of road tax for the vehicle. In France and some other EU countries, mopeds with a displacement of less than 50 cc (3.1 cu in) can be driven with minimum qualifications.

  6. Chrysler LA engine - Wikipedia

    en.wikipedia.org/wiki/Chrysler_LA_engine

    It was fitted to a low-restriction exhaust system with a 2.5 in (64 mm) exhaust pipe, collector-type Y-junction, and exposed resonator. For 1965 (only), the muffler was of "straight through" construction. A special version, exclusive to the 1966 Dodge Dart, was available. It used a 0.5 in (12.7 mm) lift solid-lifter camshaft, fabricated-steel ...

  7. Buick V8 engine - Wikipedia

    en.wikipedia.org/wiki/Buick_V8_engine

    The 322 Fireball V8 in a 1956 Buick Century. Buick's first generation V8 was offered from 1953 through 1956; it replaced the Buick straight-eight.While officially called the "Fireball V8" [1] by Buick, it became known by enthusiasts as the "Nailhead" for the unusual vertical alignment of its small-sized valves (Originally it was known to hot-rodders as the "nail valve", because the engine's ...

  1. Ads

    related to: 3.5 header collector gasket sizes