enow.com Web Search

  1. Ads

    related to: single port vs dual memory card

Search results

  1. Results from the WOW.Com Content Network
  2. Dual-ported RAM - Wikipedia

    en.wikipedia.org/wiki/Dual-ported_RAM

    Dual-ported RAM (DPRAM), also called dual-port RAM, is a type of random-access memory (RAM) that can be accessed via two different buses.. A simple dual-port RAM may allow only read access through one of the ports and write access through the other, in which case the same memory location cannot be accessed simultaneously through the ports since a write operation modifies the data and therefore ...

  3. Comparison of memory cards - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_memory_cards

    PS Vita Memory Card 2012 64 GB Subcompact (15 mm × 12.5 mm × 1.6 mm [7]), compulsory DRM, up to 64 GB, proprietary (can be used on PS Vita only) P2 (storage media) Panasonic MicroP2: 2012 64 GB MicroP2 is a SDXC/SDHC card conforming to UHS-II (Ultra High Speed bus), and can be read by common SDHC/SDXC card readers. xD: Olympus, Fujifilm, Sony

  4. Dual-ported video RAM - Wikipedia

    en.wikipedia.org/wiki/Dual-ported_video_RAM

    Dual-ported video RAM (VRAM) is a dual-ported variant of dynamic RAM (DRAM), which was once commonly used to store the framebuffer in graphics adapters. Dual-ported RAM allows the CPU to read and write data to memory as if it were a conventional DRAM chip, while adding a second port that reads out data.

  5. DIMM - Wikipedia

    en.wikipedia.org/wiki/DIMM

    A DIMM (Dual In-Line Memory Module) is a popular type of memory module used in computers. It is a printed circuit board with one or both sides (front and back) holding DRAM chips and pins . [ 1 ] The vast majority of DIMMs are manufactured in compliance with JEDEC memory standards , although there are proprietary DIMMs.

  6. PC Card - Wikipedia

    en.wikipedia.org/wiki/PC_Card

    They are 3.3 millimetres (0.13 in) thick and have a dual row of 34 holes (68 in total) along a short edge as a connecting interface. Type-I PC Card devices are typically used for memory devices such as RAM, flash memory, OTP (One-Time Programmable), and SRAM cards. Type II introduced with version 2.0 of the standard. [14]

  7. Static random-access memory - Wikipedia

    en.wikipedia.org/wiki/Static_random-access_memory

    Synchronous memory interface is much faster as access time can be significantly reduced by employing pipeline architecture. Furthermore, as DRAM is much cheaper than SRAM, SRAM is often replaced by DRAM, especially in the case when a large volume of data is required. SRAM memory is, however, much faster for random (not block / burst) access.

  1. Ads

    related to: single port vs dual memory card