Search results
Results from the WOW.Com Content Network
In aqueous solution, ammonia deprotonates a small fraction of the water to give ammonium and hydroxide according to the following equilibrium: . NH 3 + H 2 O ⇌ NH + 4 + OH −.. In a 1 M ammonia solution, about 0.42% of the ammonia is converted to ammonium, equivalent to pH = 11.63 because [NH +
The toxicity of ammonia is dependent on both pH and temperature and an added complexity is the buffering effect of the blood/water interface across the gill membrane which masks any additional toxicity over about pH 8.0. The management of river chemistry to avoid ecological damage is particularly difficult in the case of ammonia as a wide range ...
The ocean contains a natural buffer system to maintain a pH between 8.1 and 8.3. [11] The oceans buffer system is known as the carbonate buffer system. [ 12 ] The carbonate buffer system is a series of reactions that uses carbonate as a buffer to convert C O 2 {\displaystyle \mathrm {CO_{2}} } into bicarbonate . [ 12 ]
By accounting for the self-ionization of water, the true pH of the solution can be calculated. For example, a 5 × 10 −8 M solution of HCl would have a pH of 6.89 when treated as a mixture of HCl and water. The self-ionization equilibrium of solutions of sodium hydroxide at higher concentrations must also be considered.
Heating at higher temperatures results in decomposition into ammonia, nitrogen, sulfur dioxide, and water. [17] As a salt of a strong acid (H 2 SO 4) and weak base (NH 3), its solution is acidic; the pH of 0.1 M solution is 5.5. In aqueous solution the reactions are those of NH + 4 and SO 2−
Ammonia is found throughout the Solar System on Mars, Jupiter, Saturn, Uranus, Neptune, and Pluto, among other places: on smaller, icy bodies such as Pluto, ammonia can act as a geologically important antifreeze, as a mixture of water and ammonia can have a melting point as low as −100 °C (−148 °F; 173 K) if the ammonia concentration is ...
Buffer capacity falls to 33% of the maximum value at pH = pK a ± 1, to 10% at pH = pK a ± 1.5 and to 1% at pH = pK a ± 2. For this reason the most useful range is approximately p K a ± 1. When choosing a buffer for use at a specific pH, it should have a p K a value as close as possible to that pH.
Pourbaix diagram of iron. [1] The Y axis corresponds to voltage potential. In electrochemistry, and more generally in solution chemistry, a Pourbaix diagram, also known as a potential/pH diagram, E H –pH diagram or a pE/pH diagram, is a plot of possible thermodynamically stable phases (i.e., at chemical equilibrium) of an aqueous electrochemical system.