Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Groove joint: Like the dado joint, except that the slot is cut with the grain. Sometimes referred to interchangeably with the dado joint. Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint
Wood can be manufactured with a variety of different installation systems: Tongue-and-groove: One side and one end of the plank have a groove, the other side and end have a tongue (protruding wood along an edge's center). The tongue and groove fit snugly together, thus joining or aligning the planks, and are not visible once joined.
A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will be painted to hide their appearance, but ...
the tenon tongue. The tenon, formed on the end of a member generally referred to as a rail, fits into a square or rectangular hole cut into the other, corresponding member. The tenon is cut to fit the mortise hole exactly. It usually has shoulders that seat when the joint fully enters the mortise hole.
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
The main interior staircase is composed of three flights in a square 'U' shape and is finished in oak handrails supported by gothic arch balusters. Upper and lower flooring is 1-inch (25 mm) blind-nailed hard pine tongue and groove. Hard pine steps make up the stairs. The building holds approximately 5,500 square feet (510 m 2) of floor space ...
A tapered or scarfed finger joint is the most common joint used to form long pieces of lumber from solid boards; the result is finger-jointed lumber.. The finger joint can also be valuable when creating baseboards, moulding or trim, and can be used in such things as floor boards, and door construction.