Search results
Results from the WOW.Com Content Network
SRAM will hold its data permanently in the presence of power, while data in DRAM decays in seconds and thus must be periodically refreshed. SRAM is faster than DRAM but it is more expensive in terms of silicon area and cost. Typically, SRAM is used for the cache and internal registers of a CPU while DRAM is used for a computer's main memory.
Flash memory is an electronic non-volatile computer memory storage medium that can be electrically erased and reprogrammed. The two main types of flash memory, NOR flash and NAND flash, are named for the NOR and NAND logic gates. Both use the same cell design, consisting of floating-gate MOSFETs. They differ at the circuit level depending on ...
In SRAM, the memory cell is a type of flip-flop circuit, usually implemented using FETs. This means that SRAM requires very low power when not being accessed, but it is expensive and has low storage density. A second type, DRAM, is based around a capacitor. Charging and discharging this capacitor can store a "1" or a "0" in the cell.
Flash memory – In this type the writing process is intermediate in speed between EEPROMS and RAM memory; it can be written to, but not fast enough to serve as main memory. It is often used as a semiconductor version of a hard disk , to store files.
Like an SRAM, Linear Flash supports execute in place (XIP) applications in mobile PC and embedded equipment. [1] Linear Flash can also be read and written to by laptops and desktops with PC card slots, and is somewhat popular for sensitive data storage because the media is non-volatile and does not degrade over time.
The differences compared to flash are far more significant, with write speeds as much as thousands of times faster. However, these speed comparisons are not for like-for-like current. High-density memory requires small transistors with reduced current, especially when built for low standby leakage.
CMOS memory was commercialized by RCA, which launched a 288-bit CMOS SRAM memory chip in 1968. [23] CMOS memory was initially slower than NMOS memory, which was more widely used by computers in the 1970s. [24] In 1978, Hitachi introduced the twin-well CMOS process, with its HM6147 (4 kb SRAM) memory chip, manufactured with a 3 μm process. The ...
Non-volatile random-access memory (NVRAM) is random-access memory that retains data without applied power. This is in contrast to dynamic random-access memory (DRAM) and static random-access memory (SRAM), which both maintain data only for as long as power is applied, or forms of sequential-access memory such as magnetic tape, which cannot be randomly accessed but which retains data ...