Ads
related to: utp patch cable vs ethernet port converter adapter- New Zoro Brand products
Budget-friendly and project-tough.
Tested by our own product experts!
- Z-Mail Sign Up
Save 10% on Your Order.
Sign up for Z-Mail Today!
- New Zoro Brand products
crutchfield.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs).
These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.
An Ethernet crossover cable is a type of twisted pair Ethernet cable used to connect computing devices together directly that would normally be connected via a network switch, Ethernet hub or router, such as directly connecting two personal computers via their network adapters. Most current Ethernet devices support Auto MDI-X, so it does not ...
A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.
Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]
Ads
related to: utp patch cable vs ethernet port converter adaptercrutchfield.com has been visited by 100K+ users in the past month