Search results
Results from the WOW.Com Content Network
A diagram of an aquaplaning tire Two vehicles aquaplaning through large puddles on the road's surface. Aquaplaning or hydroplaning by the tires of a road vehicle, aircraft or other wheeled vehicle occurs when a layer of water builds between the wheels of the vehicle and the road surface, leading to a loss of traction that prevents the vehicle from responding to control inputs.
When a trailer skids to one side, this is known as a trailer swing or trailer slew. This can occur on a slippery road surface, often where there is a cant . This is not the same as jackknifing and is not as serious, as the trailer will move back into line as the vehicle continues forwards.
An automobile skid is an automobile handling condition where one or more tires are slipping relative to the road, and the overall handling of the vehicle has been affected. Subtypes of skid include: fishtailing, where the vehicle yaws back and forth across the direction of motion. spin or spinout where a vehicle rotates in one direction during ...
It is a result of snow, ice, water, loose material and the texture of the road surface on the traction produced by the wheels of a vehicle. [ 1 ] Road slipperiness can be measured either in terms of the friction between a freely-spinning wheel and the ground, or the braking distance of a braking vehicle, and is related to the coefficient of ...
During fishtailing, [2] the rear end of the car skids to one side, which must be offset by the driver counter-steering, which is turning the front wheels in the same direction as the skid, (e.g. left if the rear swings left) [1] and reducing engine power. Over-correction will result in a skid in the opposite direction; hence the name.
During corner entry the front tires, in addition to generating part of the lateral force required to accelerate the car's centre of mass into the turn, also generate a torque about the car's vertical axis that starts the car rotating into the turn. However, the lateral force being generated by the rear tires is acting in the opposite torsional ...
A skilled driver may stop a rollover by stopping a turn. Stunt drivers deliberately use ramps to launch a rollover. Vehicles with a high center of gravity are easily upset or "rolled." Short of a rollover, stunt drivers may also drive the car on two wheels for some time, but this requires precise planning and expert driver control.
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).