Search results
Results from the WOW.Com Content Network
Megavoltage X-rays are produced by linear accelerators ("linacs") operating at voltages in excess of 1000 kV (1 MV) range, and therefore have an energy in the MeV range. The voltage in this case refers to the voltage used to accelerate electrons in the linear accelerator and indicates the maximum possible energy of the photons which are subsequently produced. [1]
LIGA consists of three main processing steps: lithography, electroplating, and molding. There are two main LIGA-fabrication technologies, X-Ray LIGA, which uses X-rays produced by a synchrotron to create high-aspect-ratio structures, and UV LIGA, a more accessible method which uses ultraviolet light to create structures with relatively low aspect ratios.
In general, an X-ray's beam intensity is not uniform. When it focuses to a target, a conical shape appears (divergent beam). The intensity of the beam from the positive anode side is lower than the intensity from the negative cathode side because the photons created when the electrons strike the target have a longer way to travel through the rotating target on the anode side.
X-ray lithography is a process used in semiconductor device fabrication industry to selectively remove parts of a thin film of photoresist. It uses X-rays to transfer a geometric pattern from a mask to a light-sensitive chemical photoresist , or simply "resist," on the substrate to reach extremely small topological size of a feature.
A powder X-ray diffractometer in motion. X-ray crystallography is the experimental science of determining the atomic and molecular structure of a crystal, in which the crystalline structure causes a beam of incident X-rays to diffract in specific directions.
Making a radiograph. Industrial radiography is a modality of non-destructive testing that uses ionizing radiation to inspect materials and components with the objective of locating and quantifying defects and degradation in material properties that would lead to the failure of engineering structures.
A beam that is wide along the cathode–anode axis contains a wider range of X-ray intensities than a narrow beam. In a wide beam, a large image receptor captures a wider range of X-ray intensities than a small receptor (at the same SID). Both of these factors influence the visibility of the anode heel effect.
An X-ray generator generally contains an X-ray tube to produce the X-rays. Possibly, radioisotopes can also be used to generate X-rays. [1]An X-ray tube is a simple vacuum tube that contains a cathode, which directs a stream of electrons into a vacuum, and an anode, which collects the electrons and is made of tungsten to evacuate the heat generated by the collision.