Search results
Results from the WOW.Com Content Network
It is one of the most common alloys of aluminium for general-purpose use. It is commonly available in pre-tempered grades such as 6061-O (annealed), tempered grades such as 6061-T6 (solutionized and artificially aged) and 6061-T651 (solutionized, stress-relieved stretched and artificially aged).
Pages for logged out editors learn more. Contributions; Talk; 6061-T6 aluminum
2014 aluminium alloy (aluminum) is an aluminium-based alloy often used in the aerospace industry. [1] It is easily machined in certain tempers, and among the strongest available aluminium alloys, as well as having high hardness. However, it is difficult to weld, as it is subject to cracking. [2]
AlMgSi is one of the hardenable aluminum alloys, i.e. those that can become firmer and harder through heat treatment. This curing is largely based on the excretion of magnesium silicide (Mg 2 Si). The AlMgSi alloys are therefore understood in the standards as a separate group (6000 series) and not as a subgroup of aluminum-magnesium alloys that ...
can induction hardening used for 6061 grade —Preceding unsigned comment added by 59.95.19.160 14:48, 19 July 2009 (UTC) The strength values for T-0 temper seem too high. Unless I am misinterpretting something, a zero temper has strength comparable to T4 or T6, despite later in teh article it states that it has lost 80% of its strength.
It has a chemical composition of 6% aluminum, 4% vanadium, 0.25% (maximum) iron, 0.2% (maximum) oxygen, and the remainder titanium. [19] It is significantly stronger than commercially pure titanium (grades 1-4) while having the same stiffness and thermal properties (excluding thermal conductivity, which is about 60% lower in Grade 5 Ti than in ...
6060 aluminium alloy is an alloy in the wrought aluminium-magnesium-silicon family (6000 or 6xxx series). It is much more closely related to the alloy 6063 than to 6061.The main difference between 6060 and 6063 is that 6063 has a slightly higher magnesium content.
ASTM B 221: Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes; EN 573-3: Aluminium and aluminium alloys. Chemical composition and form of wrought products. Chemical composition and form of products; EN 755-2: Aluminium and aluminium alloys. Extruded rod/bar, tube and profiles. Mechanical ...