Search results
Results from the WOW.Com Content Network
It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America. American historic carpentry is the historic methods with which wooden buildings were built in what is now the United States since European settlement.
Balloon framing is a method of wood construction used primarily in areas rich in softwood forests such as Scandinavia, Canada, the United States up until the mid-1950s, and around Thetford Forest in Norfolk, England.
Timber design or wood design is a subcategory of structural engineering that focuses on the engineering of wood structures. Timber is classified by tree species (e.g., southern pine, douglas fir, etc.) and its strength is graded using numerous coefficients that correspond to the number of knots, the moisture content, the temperature, the grain ...
Wattle and daub is a composite building method used for making walls and buildings, in which a woven lattice of wooden strips called "wattle" is "daubed" with a sticky material usually made of some combination of wet soil, clay, sand, animal dung and straw. Wattle and daub has been used for at least 6,000 years and is still an important ...
Also used to describe log building), corner post construction, post-and-plank, Ständerbohlenbau (German) and skiftesverk (Swedish). This traditional building method is believed to be the predecessor to half-timber construction widely known by its German name fachwerkbau which has wall infill of wattle and daub, brick, or stone. This carpentry ...
Cordwood masonry wall detail. The method is sometimes called stackwall because the effect resembles a stack of cordwood. A section of a cordwood home. Cordwood construction (also called cordwood masonry or cordwood building, alternatively stackwall or stovewood particularly in Canada) is a term used for a natural building method in which short logs are piled crosswise to build a wall, using ...
Panels are made slightly smaller than the available space within the frame to provide room for movement. Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door.
This method eliminates the need for mitre joints, face nailing, and the use of joints on 16-inch (410 mm) or 24-inch (610 mm) centres of conventional framing. For many uses, tongue and groove boards have been rendered obsolete by the introduction of plywood and later composite wood boards, but the method is still used in higher-quality boards.