Search results
Results from the WOW.Com Content Network
The first nine blocks in the solution to the single-wide block-stacking problem with the overhangs indicated. In statics, the block-stacking problem (sometimes known as The Leaning Tower of Lire (Johnson 1955), also the book-stacking problem, or a number of other similar terms) is a puzzle concerning the stacking of blocks at the edge of a table.
The maximum height, width, and length of general Chinese rolling stock are 4,800 mm (15 ft 9 in), 3,400 mm (11 ft 2 in) and 26 m (85 ft 4 in) respectively, with an extra out-of-gauge load allowance of height and width 5,300 by 4,450 mm (17 ft 5 in by 14 ft 7 in) with some special shape limitation, corresponding to a structure gauge of 5,500 by ...
In the deck-type bridge, a wood, steel or reinforced concrete bridge deck is supported on top of two or more plate girders, and may act compositely with them. In the case of railroad bridges, the railroad ties themselves may form the bridge deck, or the deck may support ballast on which the track is laid.
A grid deck uses beams and diaphragms as the supporting structure. The supporting system of a grid deck is analyzed using a grillage analysis. A slab deck is one where the deck is analyzed as a plate. If the slab has a stiffness that is different in two directions (at right angles), then the deck is known and analyzed as an orthotropic deck.
A concrete girder bridge pier during construction prior to installation of the bridge deck and parapets, consisting of multiple angled pylons for support (bottom), a horizontal concrete cap (center), and girders (top) with temporary wood bracing. The substructure is made of multiple parts as well:
There have been a growing number of deck failures resulting in death and critical injuries. Another key component of decks are code compliant railings. Railings on decks above 760 mm (30 in) are considered guard rails. [according to whom?] Guard rails have a specific building code requirement for both height and structural strength. Most U.S ...
The simplest beam bridge could be a log (see log bridge), a wood plank, or a stone slab (see clapper bridge) laid across a stream. Bridges designed for modern infrastructure will usually be constructed of steel or reinforced concrete, or a combination of both. The concrete elements may be reinforced or prestressed.
RMS Olympic's deck The upper deck of the Falls of Clyde is iron; a centre strip is planked with wood as a sort of walkway. As is typical for a late-19th-century vessel, several deckhouses may be seen. A deck is a permanent covering over a compartment or a hull [1] of a ship.