enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Crankcase ventilation system - Wikipedia

   en.wikipedia.org/wiki/Crankcase_ventilation_system

   This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.

3. Air-blast injection - Wikipedia

   en.wikipedia.org/wiki/Air-blast_injection

   Before the invention of precombustion chamber injection, air-blast injection was the only way a properly working internal air fuel mixture system could be built, required for a Diesel engine. During the 1920s, [2] air-blast injection was rendered obsolete by superior injection system designs that allowed much smaller but more powerful engines. [3]

4. Secondary air injection - Wikipedia

   en.wikipedia.org/wiki/Secondary_air_injection

   A sensitive reed valve assembly called the aspirator valve is placed in the air injection pumping, which draws its air directly from the clean side of the air filter. During engine idle, brief but periodic negative pressure pulses in the exhaust system draw air through the aspirator valve and into the exhaust stream at the catalytic converter.

5. Anti-dribble valve - Wikipedia

   en.wikipedia.org/wiki/Anti-dribble_valve

   The valve resembles a typical spring-loaded check valve, with a small addition for the anti-dribble function. These valves are mounted on the outlet fittings of the fuel injection pump, one per cylinder injector. They are always mounted at the pump end of the pipes between the pump and injectors.

6. Swirl flap - Wikipedia

   en.wikipedia.org/wiki/Swirl_flap

   Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.

7. Fuel injection - Wikipedia

   en.wikipedia.org/wiki/Fuel_injection

   Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.