Search results
Results from the WOW.Com Content Network
Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent (direct-drive) gearing. A commonly used metric alternative is known as metres of development or rollout distance , which specifies how many metres a bicycle travels per revolution of the crank.
It is used as a measure of the effective size of a gear. The test radius of the master, plus the test radius of the work gear is the set up center distance on a composite action test device. Test radius is not the same as the operating pitch radii of two tightly meshing gears unless both are perfect and to basic or standard tooth thickness.
Gain ratio is the ratio between the distance travelled by the bicycle and the distance travelled by a pedal, and is a pure number, independent of any units of measurement. Front/rear gear measurement uses two numbers (e.g. 53/19) where the first is the number of teeth in the front chainring and the second is the number of teeth in the rear ...
A gear [1] [2] or gearwheel [3] ... The standard pitch diameter is a design dimension and cannot be measured, but is a location where other measurements are made.
Cadence can be measured via various types of sensors, for example a simple reed switch and a magnet which detects one revolution each time the crank arm passes a point on the frame, or more advanced sensors based on a force sensor (e.g. pedals), torque sensor (e.g. crank arms) or other types of cycling power sensors.
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
Calipers measure the female minor diameter (inside diameter, ID), which is less than caliper measurement of the male major diameter (outside diameter, OD). For example, tables of caliper measurements show 0.69 female ID and 0.75 male OD for the standards of "3/4 SAE J512" threads and "3/4-14 UNF JIS SAE-J514 ISO 8434-2". [ 6 ]
Pressure angles. Pressure angle in relation to gear teeth, also known as the angle of obliquity, [1] is the angle between the tooth face and the gear wheel tangent. It is more precisely the angle at a pitch point between the line of pressure (which is normal to the tooth surface) and the plane tangent to the pitch surface.