enow.com Web Search

  1. Ads

    related to: 10g ethernet standard wiring

Search results

  1. Results from the WOW.Com Content Network
  2. 10 Gigabit Ethernet - Wikipedia

    en.wikipedia.org/wiki/10_Gigabit_Ethernet

    10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.

  3. IEEE 802.3 - Wikipedia

    en.wikipedia.org/wiki/IEEE_802.3

    IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of Institute of Electrical and Electronics Engineers (IEEE).

  4. Gigabit Ethernet - Wikipedia

    en.wikipedia.org/wiki/Gigabit_Ethernet

    1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and Cat 6).

  5. Ethernet physical layer - Wikipedia

    en.wikipedia.org/wiki/Ethernet_physical_layer

    10 Gigabit Ethernet is a version of Ethernet with a nominal data rate of 10 Gbit/s, ten times as fast as Gigabit Ethernet. The first 10 Gigabit Ethernet standard, IEEE Std 802.3ae-2002, was published in 2002. Subsequent standards encompass media types for single-mode fiber (long haul), multi-mode fiber (up to 400 m), copper backplane (up to 1 m ...

  6. Media-independent interface - Wikipedia

    en.wikipedia.org/wiki/Media-independent_interface

    10 gigabit media-independent interface (XGMII) is a standard defined in IEEE 802.3 designed for connecting full duplex 10 Gigabit Ethernet (10GbE) ports to each other and to other electronic devices on a printed circuit board (PCB). It is now typically used for on-chip connections. PCB connections are now mostly accomplished with XAUI.

  7. ISO/IEC 11801 - Wikipedia

    en.wikipedia.org/wiki/ISO/IEC_11801

    The Category 7 cable standard was ratified in 2002, and primarily introduced to support 10 gigabit Ethernet over 100 m of copper cabling. [2] It contains four twisted copper wire pairs, just like the earlier standards, terminated either with GG45 electrical connectors or with TERA connectors rated for transmission frequencies of up to 600 MHz. [3]

  1. Ads

    related to: 10g ethernet standard wiring