enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   A machine screw is screwed into the sleeve, causing the anchor to bend, expand, spread and grip against the inside of the hole or behind it (in hollow contexts such as drywall over stud cavities, or hollow doors). [1] Mollies come in various diameters and grip lengths (shank lengths) for different drywall thicknesses and to support different ...

3. Drywall anchor - Wikipedia

   en.wikipedia.org/wiki/Drywall_anchor

   A drywall anchor, also known as a wall anchor, is an insert that, combined with the appropriate screw, can create a strong mount anywhere on a drywall panel or similar hollow wall. [1] A drywall anchor goes between the screw and the drywall, gripping the drywall much more effectively than a screw would. [ 2 ]

4. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]

5. Drywall - Wikipedia

   en.wikipedia.org/wiki/Drywall

   Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

6. Plaster veneer - Wikipedia

   en.wikipedia.org/wiki/Plaster_veneer

   Typically, drywall is surfaced using the "mud-and-tape" method, where non-adhesive paper or mesh tape and drywall joint compound ("mud") is used to fill joints, cover nail heads, and repair any flaws. Plaster veneer was developed as a way of taking advantage of the reduced labor of modern drywall, while providing a genuine plaster surface for a ...

7. Pressurized wall - Wikipedia

   en.wikipedia.org/wiki/Pressurized_wall

   After the frame-out process, 1 1 ⁄ 4" (32 mm) sheet rock screws are used to attach the drywall to the pressurized 2×4s that contact the floor, the ceiling and the sides of the property's walls. In order to prevent structural or architectural damage , only T-nuts and leveling screw pads are used on those studs.

8. Mat (picture framing) - Wikipedia

   en.wikipedia.org/wiki/Mat_(picture_framing)

   In the picture framing industry, a mat (or matte, or mount in British English) is a thin, flat piece of paper-based material included within a picture frame, which serves as additional decoration and to perform several other, more practical functions, such as separating the art from the glass.

9. Ceiling - Wikipedia

   en.wikipedia.org/wiki/Ceiling

   A ceiling can also be the upper limit of a tunnel. The most common type of ceiling is the dropped ceiling, [citation needed] which is suspended from structural elements above. Panels of drywall are fastened either directly to the ceiling joists or to a few layers of moisture-proof plywood which are then attached to the joists. Pipework or ducts ...