Search results
Results from the WOW.Com Content Network
A deadbolt or deadlock is a type of lock morticed into a wooden door where a bolt is thrown into the door frame, using a key from either side, to secure the door. [ 1 ] It is distinct from a spring bolt lock because a deadbolt can only be opened by a key or handle.
The first modern direct-pull electromagnetic lock was designed by Sumner "Irving" Saphirstein in 1969 [6] [7] [8] for initial installation on doors at the Montreal Forum. [9] Fire concerns by local authorities in locking the doors at the Forum prompted management to find a locking solution that would be safe during a fire incident.
The first known example of a tumbler lock was found in the ruins of the Palace of Khorsabad built by king Sargon II (721–705 BC.) in Iraq. [1] Basic principles of the pin tumbler lock may date as far back as 2000 BC in Egypt; the lock consisted of a wooden post affixed to the door and a horizontal bolt that slid into the post.
For premium support please call: 800-290-4726 more ways to reach us more ways to reach us
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
A smart lock is an electromechanical lock that is designed to perform locking and unlocking operations on a door when it receives a prompt via an electronic keypad, biometric sensor, access card, Bluetooth, or Wi-FI from a registered mobile device. These locks are called smart locks because they use advanced technology and Internet ...
DIN 18101/1985 defines interior single molded doors to have a common panel height of 1985 mm (normativ height 2010 mm) at panel widths of 610 mm, 735 mm, 860 mm, 985 mm, 1110 mm, plus a larger door panel size of 1110 mm x 2110 mm. [25] The newer DIN 18101/2014 drops the definition of just five standard door sizes in favor of a basic raster ...
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.