Search results
Results from the WOW.Com Content Network
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
By using VLANs, one can control traffic patterns and react quickly to employee or equipment relocations. VLANs provide the flexibility to adapt to changes in network requirements and allow for simplified administration. [3] VLANs can be used to partition a local network into several distinctive segments, for instance: [4] Production; Voice over IP
It is a method of inter-VLAN routing where one router is connected to a switch via a single cable. The router has physical connections to the broadcast domains where one or more VLANs require the need for routing between them. Devices on separate VLANs or in a typical local area network are unable to
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
The technique specified by the standard is known informally as stacked VLANs or QinQ. The original 802.1Q specification allows a single virtual local area network (VLAN) header to be inserted into an Ethernet frame. QinQ allows multiple VLAN tags to be inserted into a single frame, an essential capability for implementing metro Ethernet.
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and reduces the need to configure ...
In contrast to standard Ethernet according to IEEE 802.3 and Ethernet bridging according to IEEE 802.1Q, time is very important in TSN networks.For real-time communication with hard, non-negotiable time boundaries for end-to-end transmission latencies, all devices in this network need to have a common time reference and therefore, need to synchronize their clocks among each other.