enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Display size - Wikipedia

   en.wikipedia.org/wiki/Display_size

   Common screen dimensions are listed in the table below (the most common diagonal dimensions in inches as of 2020 are bolded). If the display is not listed, then the following equations can be used. Note that D is the diagonal (in centimeters or inches), W is the width (in pixels), and H is the height (in pixels).

3. Square inch - Wikipedia

   en.wikipedia.org/wiki/Square_inch

   The following symbols are used to denote square inches: square in; sq inches, sq inch, sq in; inches/-2, inch/-2, in/-2; inches^2, inch^2, in^2; inches 2, inch 2, in 2 (also denoted by "2) historic engineering drawings ″ (number with a square & a double apostrophe, both as an exponent) The square inch is a common unit of measurement in the ...

4. Photo print sizes - Wikipedia

   en.wikipedia.org/wiki/Photo_print_sizes

   The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...

5. Units of textile measurement - Wikipedia

   en.wikipedia.org/wiki/Units_of_textile_measurement

   Ends per inch (EPI or e.p.i.) is the number of warp threads per inch of woven fabric. [12] [22] In general, the higher the ends per inch, the finer the fabric is. Ends per inch is very commonly used by weavers who must use the number of ends per inch in order to pick the right reed to weave with. The number of ends per inch varies on the ...

6. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

7. Template:Convert - Wikipedia

   en.wikipedia.org/wiki/Template:Convert

   Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...