Search results
Results from the WOW.Com Content Network
A pipe near the bottom of the blowoff tank maintains a water level below the blowdown entry point and allows cooler water remaining from earlier blowdown events to drain from the tank first. Two bottom blowdown valves are often used in series to minimize erosion. One valve serves as the sealing valve, and the other as the blowdown valve.
Safety valve: It is used to relieve pressure and prevent possible explosion of a boiler. Water level indicators: They show the operator the level of fluid in the boiler, also known as a sight glass, water gauge or water column. Bottom blowdown valves: They provide a means for removing solid particulates that condense and lie on the bottom of a ...
The multiple-valve superheater header was of the Melesco type. The boiler was fitted with four Ross-pop safety valves, each 2 + 1 ⁄ 2 inches (64 millimetres) in diameter, and two Hopkinson boiler blowdown cocks on the firebox wrapper, one on each side. Feedwater was delivered to the boiler by two Friedmann vertical type non-lifting injectors ...
A blowdown valve (BDV) is a type of shutdown valve designed to depressurize a pressure vessel by directing vapour to a flare, vent or blowdown stack in an emergency. BDVs fail-safe to the open position upon failure of the control system. [1] The type of valve, type of actuation and performance measurement are similar to an ESD valve.
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
A blow-down valve mounted at the water-level of a boiler, used to blow down lighter oily or foamy deposits within a boiler that float on the water-level. Sludge another term for mud. Smokebox an enclosed space at the extremity of a fire-tube boiler, where the exhaust gases from the tubes are combined and pass to the flue or chimney. Snifting valve
Blowdown from several systems may be combined in a blowdown header prior to the stack. A knock-out pot may be provided at the base of the stack to remove any liquids. Blowdown stacks may either be ignited (like a flare) or un-ignited (a ‘cold’ vent). The height of the blowdown stack must be tall enough to ensure the safe dispersal of vapour.
A relief valve DN25 on cooling water pipe from heat exchanger Schematic diagram of a conventional spring-loaded pressure relief valve. A relief valve or pressure relief valve (PRV) is a type of safety valve used to control or limit the pressure in a system; excessive pressure might otherwise build up and create a process upset, instrument or equipment failure, explosion, or fire.