Search results
Results from the WOW.Com Content Network
The output part of the simple current mirror is an example of such a current source widely used in integrated circuits. The common base, common gate and common grid configurations can serve as constant current sources as well. A JFET can be made to act as a current source by tying its gate to its source. The current then flowing is the I DSS of ...
There are three main specifications that characterize a current mirror. The first is the transfer ratio (in the case of a current amplifier) or the output current magnitude (in the case of a constant current source CCS). The second is its AC output resistance, which determines how much the output current varies with the voltage applied to the ...
Figure 1: A version of the Widlar current source using bipolar transistors. Figure 1 is an example Widlar current source using bipolar transistors, where the emitter resistance R 2 is connected to the output transistor Q 2, and has the effect of reducing the current in Q 2 relative to Q 1.
For values of V GS near zero, the drain-to-source voltage linearization voltage or triode breakpoint is much higher than when V GS levels are near the pinch-off voltage. This means in order to maintain constant resistor behavior for different values of V GS, the maximal linearization value would be set according to the highest value of V GS used.
Depletion-load processes replace this transistor with a depletion-mode NMOS at a constant gate bias, with the gate tied directly to the source. This alternative type of transistor acts as a current source until the output approaches 1, then acts as a resistor. The result is a faster 0 to 1 transition.
This is the only first order source of mismatch in the three-transistor Wilson current mirror [8] Second, at high currents the current gain, β, of transistors decreases and the relation of collector current to base-emitter voltage deviates from = (). The severity of these effects depends on the collector voltage.
The two inductors L 1 and L 2 are used to convert respectively the input voltage source (V s) and the output voltage (V o) into current sources. At a short time scale, an inductor can be considered as a current source as it maintains a constant current.
The 2N7000 is housed in a TO92 package, with lead 1 connected as the source, lead 2 as the gate, and lead 3 as the drain. The BS170 has the source and drain leads interchanged. The 2N7002 variant is packaged in a TO-236 surface-mount package. The 2N7000 is an N-channel, enhancement-mode MOSFET used for low-power switching applications. [1]