Search results
Results from the WOW.Com Content Network
A routing table is a data file in RAM that is used to store route information about directly connected and remote networks. Nodes can also share the contents of their routing table with other nodes. The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet.
Routing calculates good paths through a network for information to take. For example, from node 1 to node 6 the best routes are likely to be 1-8-7-6, 1-8-10-6 or 1-9-10-6, as these are the shortest routes. Routing is the process of selecting network paths to carry network traffic. Routing is performed for many kinds of networks, including ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Administrative distance (AD) or route preference [1] is a number of arbitrary unit assigned to dynamic routes, static routes and directly-connected routes. The value is used in routers to rank routes from most preferred (low AD value) to least preferred (high AD value).
Depending on the implementation of that process, the BGP route is not necessarily selected. For example, a directly connected prefix, learned from the router's own hardware, is usually most preferred. As long as that directly connected route's interface is active, the BGP route to the destination will not be put into the routing table.
The source initially broadcasts to every router directly connected to it. These neighboring routers further forward the data to their neighbors. When a router does not wish to receive this group's data (if no other neighboring PIM routers are present and no host is interested in the group), it sends a Prune message to indicate its lack of interest.
A label with the value of 1 represents the router alert label. Traffic Class (TC): 3 bits Field for QoS (quality of service) priority and ECN (Explicit Congestion Notification). Prior to 2009 this field was called EXP. [12] Bottom of Stack (S): 1 bit If this flag is set, it signifies that the current label is the last in the stack.
A router is defined to be zero hops from directly connected networks, one hop from networks that are reachable through one other gateway. The protocol implements a distributed shortest-path methodology, and therefore requires global convergence of the routing tables after any change of link connectivity in the network.