Search results
Results from the WOW.Com Content Network
Splice site of a copper wire. Cable sleeve (lead sleeve) for connecting paper-insulated wires Insulating sleeves. The splicing of copper wires happens in the following steps: The cores are laid one above the other at the junction. The core insulation is removed. The wires are wrapped two to three times around each other .
When working on aerial cable splicing and installation, it is common to use a telephone lineman's set or "butt set" to communicate over long distances. To facilitate this, extra pairs of wires are embedded in cables using "major" colors for both wires (instead of the major/minor color combinations used for the rest).
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
Film splice, the joining of film stock; Electrical splice, the joining of wires in electrical wiring; Optical splice, the joining of optical fibers: Fusion splicing, a permanent splice between two fibers; Mechanical splice, a temporary splice between two fibers; Pile splice, connecting two concrete, timber or steel piles for a deep foundation
Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length. Long splice – A splice used to join two rope ends forming one rope the length of the total of the two ropes.
In electrical wiring, a T-splice is a splice that is used for connecting the end of one wire to the middle of another wire, thus forming a shape like that of the letter "T". This splice can be used with solid or stranded wires. The existing wire is called the main wire. The new wire that connects to the main wire is called the branch wire or ...
A rat-tail splice, also known as a twist splice or a pig-tail splice, is a basic electrical splice that can be done with both solid and stranded wire. It is made by taking two or more bare wires and wrapping them together symmetrically around the common axis of both wires. The bare splice can be insulated with electrical tape or by other means.
If colored white, it typically may be used for splicing neutral wires in a device box, while leaving a pigtail free for connection to a device (such as a receptacle). If colored green, the assembly is intended to be used as a grounding pigtail, similar to the feedthrough twist-on wire connectors without a permanently-attached wire.