enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Extended Display Identification Data - Wikipedia

    en.wikipedia.org/wiki/Extended_display...

    Standard timing information. Up to 8 2-byte fields describing standard display modes. Unused fields are filled with 01 01 hex. The following definitions apply in each record: 38: Standard timing 1: X resolution, 00 = reserved; otherwise, (datavalue + 31) × 8 (256–2288 pixels). 39 Bits 7–6: Standard timing 1: Image aspect ratio: 00 = 16:10 ...

  3. Coordinated Video Timings - Wikipedia

    en.wikipedia.org/wiki/Coordinated_Video_Timings

    In revision 1.2, released in 2013, a new "Reduced Blanking Timing Version 2" mode was added which further reduces the horizontal blanking interval from 160 to 80 pixels, increases pixel clock precision from ±0.25 MHz to ±0.001 MHz, and adds the option for a 1000/1001 modifier for ATSC/NTSC video-optimized timing modes (e.g. 59.94 Hz instead ...

  4. DisplayID - Wikipedia

    en.wikipedia.org/wiki/DisplayID

    DisplayID is a VESA standard for metadata describing display device capabilities to the video source. It is designed to replace E-EDID standard and EDID structure v1.4. The DisplayID standard was initially released in December 2007. Version 1.1 was released in March 2009 and was followed by version 1.2 released in August 2011.

  5. Generalized Timing Formula - Wikipedia

    en.wikipedia.org/wiki/Generalized_Timing_Formula

    Generalized Timing Formula is a standard by VESA which defines exact parameters of the component video signal for analogue VGA display interface.. The video parameters defined by the standard include horizontal blanking (retrace) and vertical blanking intervals, horizontal frequency and vertical frequency (collectively, pixel clock rate or video signal bandwidth), and horizontal/vertical sync ...

  6. Display Data Channel - Wikipedia

    en.wikipedia.org/wiki/Display_Data_Channel

    Version 1 was introduced in September 1999 and featured the addition of a segment pointer which allowed up to 32 Kbytes of display information storage for use by the Enhanced EDID (E-EDID) standard. Earlier DDC implementations used simple 8-bit data offset when communicating with the EDID memory in the monitor, limiting the storage size to 2 8 ...

  7. Display resolution standards - Wikipedia

    en.wikipedia.org/wiki/Display_resolution_standards

    The 1280 × 1024 resolution is not the standard 4:3 aspect ratio, instead it is a 5:4 aspect ratio (1.25:1 instead of 1. 3:1). A standard 4:3 monitor using this resolution will have rectangular rather than square pixels, meaning that unless the software compensates for this the picture will be distorted, causing circles to appear elliptical.

  8. AMD Chief Predicts Custom Chips Will Outperform GPUs ... - AOL

    www.aol.com/amd-chief-predicts-custom-chips...

    Advanced Micro Devices, Inc. (NASDAQ:AMD) chief Lisa Su shared insight into the prospects of graphics processing units (GPUs) in the near term, almost to the extent of taking a dig at rival Nvidia ...

  9. List of common display resolutions - Wikipedia

    en.wikipedia.org/wiki/List_of_common_display...

    The resolution of 960H depends on whether the equipment is PAL or NTSC based: 960H represents 960 x 576 (PAL) or 960 x 480 (NTSC) pixels. [29] 960H represents an increase in pixels of some 30% over standard D1 resolution, which is 720 x 576 pixels (PAL), or 720 x 480 pixels (NTSC). The increased resolution over D1 comes as a result of a longer ...