enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drift pin - Wikipedia

   en.wikipedia.org/wiki/Drift_pin

   This technique is especially useful for aligning fastener holes in structural steel members, which always have multiple holes, such that when one pair of mating holes comes into alignment, the others in the set are aligned, allowing a fastener, usually a bolt, to be inserted, before the drift pin is removed.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A drift "punch" is misleadingly named; it is not used as a punch in the traditional sense of the term. A drift punch, or drift pin, or lineup punch, is used as an aid in aligning bolt or rivet holes prior to inserting a fastener. A drift punch is constructed as a tapered rod, with the hammer acting on the large end of the taper.

4. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

5. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   The heads, occasionally called anvils, are attached to the rule by sliding the rule into a slot in the side of the head. The head is then tightened in place via a lock bolt or lock nut which engages with a channel running the full length of the rule, allowing the head to be tightened on at any point along the rule.

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

7. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.