enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Belt (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Belt_(mechanical)

   Belt tensions should also be adjusted to belt type, size, speed, and pulley diameters. Belt tension is determined by measuring the force to deflect the belt a given distance per inch (or mm) of pulley. Timing belts need only adequate tension to keep the belt in contact with the pulley.

3. Timing belt (camshaft) - Wikipedia

   en.wikipedia.org/wiki/Timing_belt_(camshaft)

   In a piston engine, either a timing belt (also called a cambelt) or timing chain or set of timing gears is a perishable component used to synchronize the rotation of the crankshaft and the camshaft. This synchronisation ensures that the engine's valves open and close at the correct times in relation to the position of the pistons.

4. Toothed belt - Wikipedia

   en.wikipedia.org/wiki/Toothed_belt

   A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.

5. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force.

6. Timing belt (disambiguation) - Wikipedia

   en.wikipedia.org/wiki/Timing_belt_(disambiguation)

   A timing belt, or toothed belt, is a flexible belt with teeth moulded onto its inner surface. Timing belt may also refer to: Timing belt (camshaft) , a perishable component used to synchronize the rotation of the crankshaft and the camshaft

7. Timing mark - Wikipedia

   en.wikipedia.org/wiki/Timing_mark

   A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.