enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tire changer - Wikipedia

   en.wikipedia.org/wiki/Tire_changer

   However, now, bigger versions of the heavy-duty tire changers are designed to mount/demount tires up to 95 inches (2.4 m) in diameter and also feature a hydraulically operated self-centering four-jaw chuck with clamping jaws that can clamp from 14 to 58 inches (0.36 to 1.47 m) either from the wheel’s inside or from the center bore.

3. Bead breaker - Wikipedia

   en.wikipedia.org/wiki/Bead_breaker

   A tire bead is held in the groove by air pressure. A bead breaker is a tool used for separating tires from rims. The innermost diameter of the tire that interfaces with the rim of a wheel is called the tire bead. The bead is a thicker section of rubber, and is reinforced with braided steel cables, called the bead bundle. [1]

4. Lug wrench - Wikipedia

   en.wikipedia.org/wiki/Lug_wrench

   A lug wrench, also colloquially known as a tire iron, is the name for a type of socket wrench used to loosen and tighten lug nuts on automobile wheels. In the United Kingdom and Australia, it is commonly known as a wheel brace .

5. Spare tire - Wikipedia

   en.wikipedia.org/wiki/Spare_tire

   A spare tire allows a driver to replace a flat tire and drive on A Stepney rim. An early approach to providing a car with a spare tire Dual sidemounted spare tires behind the front fenders on a 1931 Nash Ambassador Temporary use "space-saver" spare tire mounted in the trunk of a 1970 AMC AMX with a single use air canister Full size spare tire mounted in cargo space area of a 1993 Jeep Grand ...

6. Tire balance - Wikipedia

   en.wikipedia.org/wiki/Tire_balance

   If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.