enow.com Web Search

  1. Ads

    related to: ethernet 1 to 2 splitter converter cable connector installation

Search results

  1. Results from the WOW.Com Content Network
  2. DSL filter - Wikipedia

    en.wikipedia.org/wiki/DSL_filter

    At the wall jack where the DSL modem is installed, a commercial 2-line splitter adapter is used that puts each line of the cable on its own jack port, connected as Line 1. The telephone, if any, is plugged into the Line 1 jack and the DSL modem is plugged into the Line 2 jack of the adapter, but is fed through the Line 1 contacts in that jack ...

  3. Y-cable - Wikipedia

    en.wikipedia.org/wiki/Y-cable

    A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends.

  4. Ethernet - Wikipedia

    en.wikipedia.org/wiki/Ethernet

    Clockwise from top-left: An Ethernet transceiver with an in-line 10BASE2 adapter, a similar model transceiver with a 10BASE5 adapter, an AUI cable, a different style of transceiver with 10BASE2 BNC T-connector, two 10BASE5 end fittings (N connectors), an orange vampire tap installation tool (which includes a specialized drill bit at one end and ...

  5. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    Only lines 1 and 2 have electrical compatibility, with T568A wiring, and only line 1 with T568B wiring, because Ethernet-compatible pin assignments split the third pair of RJ25 across two separate cable pairs, rendering that pair unusable by an analog phone. (With T568B wiring, a telephone may connect to line 3 as line 2.) Both the third and ...

  6. Passive optical network - Wikipedia

    en.wikipedia.org/wiki/Passive_optical_network

    EPON is a "short haul" network using Ethernet packets, fiber optic cables, and single protocol layer. [1] EPON also uses standard 802.3 Ethernet frames with symmetric 1 gigabit per second upstream and downstream rates. EPON is applicable for data-centric networks, as well as full-service voice, data and video networks.

  7. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    A connection standard, such as RJ11, specifies not only the physical aspects of an electrical connector, but also the signal definitions for each contact, and the pinout of the device, i.e. the assignment or function of each contact. [1] Modular connectors are specified for the registered jack (RJ) series of connectors, as well as for Ethernet ...

  1. Ads

    related to: ethernet 1 to 2 splitter converter cable connector installation