Search results
Results from the WOW.Com Content Network
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
A Hydra-Matic 4L80 transmission at the Ypsilanti Automotive Heritage Museum. The 4L80-E (RPO MT1) is rated to handle engines with up to 440 ft·lbf (597 N·m) of torque. [2] The 4L80-E is rated to a maximum GVWR of 18,000 lb, depending on the axle and vehicle. [3]
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
By activating and deactivating the solenoids in a predetermined pattern by the PCM, 4 distinct gear ratios can be achieved. The last 4L60Es were only used in the GM Vans in 2013, before being replaced by the 6L80E. The shift solenoid pattern, also sometimes referred to as solenoid firing order, is as follows; Shift Solenoid Pattern
The 2012-2016 DPS6 Powershift transmission was used in the 2012–2016 Ford Focus and 2011–2016 Ford Fiesta sedans. This transmission is the subject of a massive number of lawsuits alleging Ford lied in order to sell cars Ford knew had defective transmissions. [9] 2008–present 6DCT450 Ford Powershift (MPS6) 6-speed wet clutch
The parking pawl locks the transmission's output shaft to the transmission casing by engaging a pawl (a pin) that engages in a notched wheel on the shaft, stopping it (and thus the driven wheels) from rotating. The main components of a parking pawl mechanism are the parking gear, parking pawl, actuator rod, cam collar, cam plate, pivot pin, and ...
The 4T80-E transmission is electronically controlled and features an automatic overdrive transaxle with an electronically controlled torque converter clutch. The 4T80 originally used a viscous clutch, but this was changed in 2005 to ECCC. [1] [4] [2] [3] The 4T80 is built at Willow Run Transmission in Ypsilanti, Michigan.