Search results
Results from the WOW.Com Content Network
The Switch Matrix is made up of discrete electronic components including RF switches and signal conditioners that are mounted together in a mechanical infrastructure or housing. Cables interconnect the switches and signal conditioners. The switch matrix employs a driver circuit and power supply to power and drive the switches and signal ...
The time domain reflectometer sends a pulse down the wire and then analyzes the returning reflected pulse to identify faults within the electrical wire. In historic submarine telegraph cables , sensitive galvanometers were used to measure fault currents; by testing at both ends of a faulted cable, the fault location could be isolated to within ...
Powering a noise-sensitive SoC or circuit component in a pulsed application with an LDO may well turn out to be a sub-optimal solution: in addition to low conversion efficiency, noise is still present on the supply bias in the form of transients which vary in both frequency and density (frequency of occurrence). [7]
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...
Fig. 2. EMI noise of output voltage for programmed switching frequency (PWM): a) Spectrum and b) Spectrogram. PWM is considered the most common deterministic technique. Considering the example of a DC-DC converter, a controlled switch is designed to “cut-off” the DC waveform into a pulse-shaped waveform.
A transformer designed specifically for the relevant frequency range must be used. Optoisolators can perform the same task for digital lines but introduce signal delay. In circuits producing high-frequency noise such as computer components, ferrite bead chokes are placed around cables just before the termination to the next appliance (e.g., the ...
A fault model, falls under one of the following assumptions: single fault assumption: only one fault occur in a circuit. if we define k possible fault types in our fault model the circuit has n signal lines, by single fault assumption, the total number of single faults is k×n. multiple fault assumption: multiple faults may occur in a circuit.
A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...