Search results
Results from the WOW.Com Content Network
A right circular cylinder is a cylinder whose generatrices are perpendicular to the bases. Thus, in a right circular cylinder, the generatrix and the height have the same measurements. [ 1 ] It is also less often called a cylinder of revolution, because it can be obtained by rotating a rectangle of sides r {\displaystyle r} and g {\displaystyle ...
A curvature line is a curve on a surface, which has at any point the direction of a principal curvature (maximal or minimal curvature). The set of curvature lines of a right circular cylinder consists of the set of circles (maximal curvature) and the lines (minimal curvature). A plane has no curvature lines, because any normal curvature is zero.
For a given volume, the right circular cylinder with the smallest surface area has h = 2r. Equivalently, for a given surface area, the right circular cylinder with the largest volume has h = 2r, that is, the cylinder fits snugly in a cube of side length = altitude ( = diameter of base circle). [8]
(I): Any Dupin cyclide is the image either of a right circular cylinder or a right circular double cone or a torus of revolution by an inversion (reflection at a sphere). The inversion at the sphere with equation x 2 + y 2 + z 2 = R 2 {\displaystyle x^{2}+y^{2}+z^{2}=R^{2}} can be described analytically by:
The area between the curve = and the axis, from = to = General spandrel: The area ... Right circular cylinder: r = the radius of the cylinder
Examples include the plane, the lateral surface of a cylinder or cone, a conical surface with elliptical directrix, the right conoid, the helicoid, and the tangent developable of a smooth curve in space. A ruled surface can be described as the set of points swept by a moving straight line.
The term “cylinder” can refer to a three-dimensional solid or, as in this article, only the curved external surface of the solid. This is why a line piercing a cylinder's volume is considered to have two points of intersection: the surface point where it enters and the one where it leaves.
The intersection of a normal plane and the surface will form a curve called a normal section and the curvature of this curve is the normal curvature. For most points on most “smooth” surfaces, different normal sections will have different curvatures; the maximum and minimum values of these are called the principal curvatures , call these κ ...