Search results
Results from the WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
In case of Back-to-Back, VRF is necessary to create VLANs and subsequently sub-interfaces (VLAN headers and DLCI headers for Ethernet and Frame Relay network packets) on each interface used for the NNI circuit. In the case of eBGP NNI interconnection, IP routers are taught how to dynamically exchange VRF records without VLAN creation.
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of VLANs on the whole local area network. VTP is available on most of the Cisco Catalyst Family products. The comparable IEEE standard in use by other manufacturers is GARP VLAN Registration Protocol (GVRP) or the more recent Multiple VLAN Registration ...
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
The port becomes a trunk port even if the neighboring port does not agree to the change. Dynamic Auto — Makes the Ethernet port willing to convert the link to a trunk link. The port becomes a trunk port if the neighboring port is set to trunk or dynamic desirable mode. This is the default mode for some switchports.
As VLANs are segmented, it reduces the amount of traffic flow through a connection. By separating VLANs, it provides enhanced network security. Network administrators have direct control over multiple broadcast domains. In the event of a malicious user attempting to access any switch port, they will have limited access to the network.