enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   A Baldwin 6-axle locomotive kit cast in resin in HO Scale. Due to aggressive nature of most compounds used for casting and the high temperature of the reaction the mold gradually degrades and loses small details. Typically, a flexible mold will yield between 25 and 100 castings depending upon the size of the part, the intensity of the heat ...

3. Molybdomancy - Wikipedia

   en.wikipedia.org/wiki/Molybdomancy

   A molybdomancy kit includes a set of shaped lead ingots, to be melted over a candle flame in a spoon. A piece of molten lead after immersion in cold water. Molybdomancy (from Ancient Greek: μόλυβδος, romanized: molybdos, lit. 'lead' [1] and -mancy) is a technique of divination using molten metal.

4. Vacuum casting (elastomers) - Wikipedia

   en.wikipedia.org/wiki/Vacuum_casting_(elastomers)

   The process starts by placing a two piece silicone mold in a vacuum chamber. The raw material is mixed, degassed and then poured into the mold. The vacuum is then released and the mold removed from the chamber. Finally, the casting is cured in an oven and the mold removed to release the completed casting. The silicone mold can be reused. [3]

5. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

6. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones also exhibit good chemical resistance and high-temperature resistance (205 °C, 400 °F and higher). For this reason, silicone molds are suitable for casting low-melt metals and alloys (e.g. zinc, tin, pewter, and Wood's metal). RTV silicone rubbers are, however, generally expensive – especially platinum-cure.

7. Permanent mold casting - Wikipedia

   en.wikipedia.org/wiki/Permanent_mold_casting

   Permanent mold casting. Permanent mold casting is a metal casting process that employs reusable molds ("permanent molds"), usually made from metal. The most common process uses gravity to fill the mold, however gas pressure or a vacuum are also used. A variation on the typical gravity casting process, called slush casting, produces

8. Injection molding of liquid silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Injection_molding_of...

   Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is ...

9. Cast bullet - Wikipedia

   en.wikipedia.org/wiki/Cast_bullet

   An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.