enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hook (hand tool) - Wikipedia

   en.wikipedia.org/wiki/Hook_(hand_tool)

   A hook is a hand tool used for securing and moving loads. It consists of a round wooden handle with a strong metal hook about 20 cm (8 inches) long projecting at a right angle from the center of the handle. The appliance is held in a closed fist with the hook projecting between two fingers.

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle.

4. Halfords - Wikipedia

   en.wikipedia.org/wiki/Halfords

   Halfords rebranded in February 2003, to the black and orange logo it has today. [5] Halfords entered into a Collaboration Agreement with Autobacs Seven Co. on 11 July 2005, [6] a Japan based car accessory retailer with chains of stores all over the world and is best known for being the title sponsor of Super GT and D1 Grand Prix. [7]

5. Tool bit - Wikipedia

   en.wikipedia.org/wiki/Tool_bit

   The supporting tool holder can then be made from a tougher steel, which besides being cheaper is also usually better suited to the task, being less brittle than the cutting-edge materials. The tool holders may also be designed to introduce additional properties to the cutting action, such as: angular approach – direction of tool travel

6. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   While modern nuts and bolts are routinely made of metal, this was not the case in earlier ages, when woodworking tools were employed to fashion very large wooden bolts and nuts for use in winches, windmills, watermills, and flour mills of the Middle Ages; the ease of cutting and replacing wooden parts was balanced by the need to resist large amounts of torque, and bear up against ever heavier ...

7. Headset (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Headset_(bicycle_part)

   In order to provide a cable stop for front cantilever brakes or centerpull brakes, a hanger may be incorporated into the headset, either as part of the washer between the top race and the lock nut in the case of threaded headsets, or as part of a spacer between the top race and the stem in the case of threadless headsets.