Search results
Results from the WOW.Com Content Network
Each of the California sign specifications is assigned an alphanumeric designation and organized according to the same series found in the SHSM. The sign designation for a state-specific sign includes a "(CA)" after the sign number. The CA MUTCD also defines some state-specific series: [8] Series G: California Guide; Series SG: California ...
The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance .
An ornate 18th century iron straightedge. A straightedge or straight edge is a tool used for drawing straight lines, or checking their straightness. If it has equally spaced markings along its length, it is usually called a ruler.
This template creates a vertical bar chart for a set of data of your choosing, for example, charting population demographics of a location. Up to twenty graphical bars can be used along with specified colors. The graph's width is set by default, but can be changed, as well as the large and small scales.
Critical dimensions as step, curvature, flatness are computed from the surface topography. While the historical notion of a profilometer was a device similar to a phonograph that measures a surface as the surface is moved relative to the contact profilometer's stylus , this notion is changing with the emergence of numerous non-contact ...
Geometrical Product Specification and Verification (GPS&V) [1] is a set of ISO standards developed by ISO Technical Committee 213. [2] The aim of those standards is to develop a common language to specify macro geometry (size, form, orientation, location) and micro-geometry (surface texture) of products or parts of products so that the language can be used consistently worldwide.
Using a dipstick to measure the amount of fuel remaining in a tank The lower end of an oil dipstick with markings for minimum and maximum oil levels. Dipsticks can also be used to measure the quantity of liquid in an otherwise inaccessible space, by inserting and removing the stick and then checking the extent of it covered by the liquid.
Ideal test indicator pushed. Prior to modern geared dial mechanisms, test indicators using a single lever or systems of levers were common. The range and precision of these devices were generally inferior to modern dial type units, with a range of 10/1000 inch to 30/1000 inch, and precision of 1/1000 inch being typical.