enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Got Trees With Dead or Damaged Limbs? There’s a Pole Saw for ...

   www.aol.com/8-best-pole-saws-every-175400659.html

   Best Pole Saws. Best Overall: DPPT-2600H eForce X Series Electric Pole Saw. Best Manual Pole Saw: FG-6PKG-7 FG-Series Manual Pole Saw. Best Value: Black and Decker 20-Volt Max Cordless Pole ...

3. Bore gauge - Wikipedia

   en.wikipedia.org/wiki/Bore_gauge

   Small-hole gauge set. Sizes from top to bottom: 3 to 5 mm (0.118 to 0.197 in) 5 to 7.5 mm (0.197 to 0.295 in) 7.5 to 10 mm (0.295 to 0.394 in) 10 to 13 mm (0.394 to 0.512 in) Small-hole gauges require a slightly different technique to the telescopic gauges, the small hole gauge is initially set smaller than the bore to be measured.

4. Polesaw - Wikipedia

   en.wikipedia.org/wiki/Polesaw

   A polesaw (also pole saw or giraffe saw) is a saw attached to a pole or long handle that is used for pruning tree branches that are beyond arm's reach. [1] [2] A polesaw allows its user to cut high branches without the use of a ladder. [3] Polesaws can be manual or motorized.

5. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.

6. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.

7. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance. This may be initially ...