Search results
Results from the WOW.Com Content Network
The entire system, consisting of the pump, the cylinder and a reservoir of hydraulic fluid, is packaged into a single self-contained unit. Instead of the energy needed to move the controls being supplied by an external hydraulic supply, it is supplied over normal electrical wiring, albeit larger wiring than what would be found in a fly-by-wire ...
A servo valve receives pressurized hydraulic fluid from a source, typically a hydraulic pump. It then transfers the fluid to a hydraulic cylinder in a closely controlled manner. Typically, the valve will move the spool proportionnaly to an electrical signal that it receives, indirectly controlling flow rate.
Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.
Motorcycles with a V-twin engine mounted with its crankshaft mounted in line with the frame, e.g. the Honda CX series, are said to have "transverse" engines, [1] [2] while motorcycles with a V-twin mounted with its crankshaft mounted perpendicular to the frame, e.g. most Harley-Davidsons, are said to have "longitudinal" engines.
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
Harley-Davidson Evolution engine at the Harley-Davidson Museum. The Evolution engine (popularly known as Evo and sometimes as Blockhead ) is an air-cooled, 45-degree, V-twin engine manufactured from 1984 by Harley-Davidson for the company's motorcycles.
The induction stroke is the first phase in a four-stroke (e.g. Otto cycle or Diesel cycle) engine.It involves the downward movement of the piston, creating a partial vacuum that draws an air-fuel mixture (or air alone, in the case of a direct injection engine) into the combustion chamber.