Search results
Results from the WOW.Com Content Network
A call for a next generation plate, to stop even greater velocity threats than the ESAPI plate was issued by the U.S. Army in 2008. [5] The X Threat Small Arms Protective Insert plates are specifically allowed scalar or flexible systems, and asked for better coverage, with less than a pound of additional weight.
A ballistic plate, also known as an armour plate, is a protective armoured plate inserted into a carrier or bulletproof vest, that can be used stand-alone, or in conjunction with other armour. "Hard armour" usually denotes armour that uses ballistic plates. It serves to defeat higher threats, and may be considered as a form of applique armour.
While E-SAPI plates do hold significant defensive advantages over the preceding SAPI plates, the increased protection comes at the cost of increased weight and significantly increased cost. Comparing medium-sized plates, a SAPI plate weighs 1.82 kg (4.0 lb) while an E-SAPI plate weighs 2.5 kg (5.5 lb), over a 35 percent increase in weight. [ 15 ]
Two versions of the vest are available, known as the "land" and "maritime" versions. The vest consists of front and rear panels with pockets for BALCS or SPEAR-cut soft armor panels and standard-issue SAPI (Small Arms Protective Insert) plates. This gives the wearer up to NIJ Level IV protection on the front and back and Level IIIA protection ...
The Soldier Plate Carrier System (SPCS), known commercially as the KDH Magnum TAC-1, is a plate carrier developed for the U.S. Army which provides protection in accordance with if not greater than, the Improved Outer Tactical Vest. [2] The SPCS is a lighter alternative to the IOTV, with increased mobility and comfort.
A common type of pin tumbler lock, of the euro cylinder type. The pin tumbler lock, also known as the Yale lock after the inventor of the modern version, is a lock mechanism that uses pins of varying lengths to prevent the lock from opening without the correct key.
Attempts have been made to increase the safety of bridges with pin and hanger assemblies by adding some form of redundancy to the assembly. Retrofits that add redundancy to pin and hanger assemblies include adding a "catcher's mitt"—a short steel beam attached to the bottom of the cantilevered girder that extends out beneath the suspended girder to "catch" the suspended girder should ...
When the door is closed, the bolt extends into the hole in the strike plate and holds the door closed. The strike plate protects the jamb against friction from the bolt and increases security in the case of a jamb made of a softer material (such as wood) than the strike plate. Some strike plates have their hole size and placement calculated so ...