Search results
Results from the WOW.Com Content Network
Benzene should NOT be used at all unless no safer alternatives are available. If benzene must be used in an experiment, it should be handled at all stages in a fume cupboard. Wear safety glasses and use protective gloves. Emergency: Eye contact: Immediately flush the eye with plenty of water. Continue for at least ten minutes
Vapor recovery towers are also used in the oil and gas industry to provide flash gas recovery at near atmospheric pressure without the chance of oxygen ingress at the top of the storage tanks. The ability to create the vapor flash inside the tower often reduces storage tank emissions to less than six tons per year, exempting the tank battery ...
log of propane vapor pressure. ... The National Propane Gas Association has a generic MSDS available online here. (Issued 1996) MSDS from Suburban Propane, ...
This is illustrated in the vapor pressure chart (see right) that shows graphs of the vapor pressures versus temperatures for a variety of liquids. [7] At the normal boiling point of a liquid, the vapor pressure is equal to the standard atmospheric pressure defined as 1 atmosphere, [ 1 ] 760 Torr, 101.325 kPa, or 14.69595 psi.
An onboard refueling vapor recovery system (ORVR) is a vehicle fuel vapor emission control system that captures volatile organic compounds (VOC, potentially harmful vapors) during refueling. [ 1 ] [ page needed ] There are two types of vehicle fuel vapor emission control systems: the ORVR, and the Stage II vapor recovery system. [ 2 ]
Reid vapor pressure (RVP) is a common measure of the volatility of gasoline and other petroleum products. [1] It is defined as the absolute vapor pressure exerted by the vapor of the liquid and any dissolved gases/moisture at 37.8 °C (100 °F) as determined by the test method ASTM-D-323, which was first developed in 1930 [2] and has been revised several times (the latest version is ASTM D323 ...
On the left-hand vertical axis, locate and mark the point containing the pressure 100 psia. On the right-hand vertical axis, locate and mark the point containing the temperature 60°F. Connect the points with a straight line. Note where the line crosses the methane axis. Read this K-value off the chart (approximately 21.3).
Flammability diagrams show the control of flammability in mixtures of fuel, oxygen and an inert gas, typically nitrogen. Mixtures of the three gasses are usually depicted in a triangular diagram, known as a ternary plot. Such diagrams are available in the speciality literature.