Search results
Results from the WOW.Com Content Network
Some applications of materials testing include defect detection, failure analysis, material development, basic materials science research, and the verification of material properties for application trials. This is a list of organizations and companies that publish materials testing standards or offer materials testing laboratory services.
Zeta Sedan. Zeta is a marque of automobile which was produced in Australia from 1963 to 1965 by South Australian manufacturing company Lightburn & Co.. An established manufacturer of cement mixers and washing machines, Lightburn and Co. built the cars in its factory in the Adelaide suburb of Camden Park.
Albert Henry Lightburn (c. 1877 – 27 October 1940) was a son of Liverpool marine engineer John Bolton Lightburn (c. 1840 – 5 May 1916) and his wife Matilda Lightburn (13 May 1847 – 10 May 1930) who arrived in South Australia from England in 1898 and lived in Athelstone until after John's death, when she lived with Albert in Unley.
A load bank is a piece of electrical test equipment used to simulate an electrical load, to test an electric power source without connecting it to its normal operating load. [ 1 ] [ 2 ] During testing, adjustment, calibration, or verification procedures, a load bank is connected to the output of a power source, such as an electric generator ...
Industrial radiography is a modality of non-destructive testing that uses ionizing radiation to inspect materials and components with the objective of locating and quantifying defects and degradation in material properties that would lead to the failure of engineering structures. It plays an important role in the science and technology needed ...
An automotive thermoelectric generator (ATEG) is a device that converts some of the waste heat of an internal combustion engine (IC) into electricity using the Seebeck Effect. A typical ATEG consists of four main elements: A hot-side heat exchanger , a cold-side heat exchanger, thermoelectric materials , and a compression assembly system.
This page was last edited on 26 January 2019, at 11:47 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The validation of aging test results is essential to ensure that the data obtained accurately represents the long-term performance and durability of a material, component, or product. Aging tests are designed to simulate real-world conditions over an accelerated timeframe, but validation is necessary to confirm that these simulations provide ...