Search results
Results from the WOW.Com Content Network
DDR2 SDRAM was designed with such a scheme to avoid an excessive increase in power consumption. DDR2's bus frequency is boosted by electrical interface improvements, on-die termination, prefetch buffers and off-chip drivers. However, latency is greatly increased as a trade-off. The DDR2 prefetch buffer is four bits deep, whereas it is two bits ...
1GB 2Rx4 PC2-3200P-333-11-D2 is a 1 GB DDR2 Registered DIMM, with address/command parity function, using 2 ranks of x4 SDRAMs operational to PC2-3200 performance with CAS Latency = 3, tRCD = 3, tRP = 3, using JEDEC SPD revision 1.1, raw card reference design file D revision 2 used for the assembly.
DDR SDRAM specification was finalized by JEDEC in June 2000 (JESD79). [9] JEDEC has set standards for the data rates of DDR SDRAM, divided into two parts. The first specification is for memory chips, and the second is for memory modules.
Corresponding 240-pin DIMMs are known as PC2-3200 through PC2-6400. DDR2 SDRAM is now available at a clock rate of 533 MHz generally described as DDR2-1066 and the corresponding DIMMs are known as PC2-8500 (also named PC2-8600 depending on the manufacturer). Performance up to DDR2-1250 (PC2-10000) is available.
Stub Series Terminated Logic (SSTL) is a group of electrical standards for driving transmission lines commonly used with DRAM based DDR memory IC's and memory modules. SSTL is primarily designed for driving the DDR (double-data-rate) SDRAM modules used in computer memory; however, it is also used in other applications, notably some PCI Express PHYs and other high-speed devices.
Memory controller with differential serial connections to DDR2 FB-DIMMs. The AMB is visible in the center of each DIMM. A Fully Buffered DIMM (FB-DIMM) is a type of memory module used in computer systems. It is designed to improve memory performance and capacity by allowing multiple memory modules to be each connected to the memory controller ...
Notch positions on DDR (top) and DDR2 (bottom) DIMM modules. On the bottom edge of 168-pin DIMMs there are two notches, and the location of each notch determines a particular feature of the module. The first notch is the DRAM key position, which represents RFU (reserved future use), registered , and unbuffered DIMM types (left, middle and right ...
For instance, under a 1,066MHz FSB, the only choices regarding memory speed in the MRC are DDR2-667 and DDR2-800. We have to provide additional choices. For people who want higher memory frequency, we used the setting of 800MHz FSB:DDR2-800 in MRC, but overclocked it to work with a 1,066MHz FSB, so we could implement support for DDR2-1066.