Search results
Results from the WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
It is a locked (pegged) mortise and tenon technique that consists of cutting two mortises into the edges of two planks; a separate rectangular tenon is then inserted in the two mortises. The assembly is then locked in place by driving a dowel through one or more holes drilled through mortise side wall and tenon. [14] [15]
In machine tools, a spindle is a rotating axis of the machine, which often has a shaft at its heart. The shaft itself is called a spindle, but also, in shop-floor practice, the word often is used metonymically to refer to the entire rotary unit, including not only the shaft itself, but its bearings and anything attached to it ( chuck , etc.).
The charkha works similarly to the great wheel, with a drive wheel being turned by one hand, while the yarn is spun off the tip of the spindle with the other. The floor charkha and the great wheel closely resemble each other. With both, yarn must be held off the end of the spindle in order to twist it, and off-axis to wind the yarn onto the ...
Spindles or uprights - Jaguar left and Holden Gemini right The wheel spindle in the illustration is colored red. In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms.
Nora Denney (September 3, 1927 [citation needed] – November 20, 2005), also credited as Dodo Denney, was an American actress. She is best remembered for her role as Mrs. Doris Teavee in Willy Wonka & the Chocolate Factory (1971).
A bedstone and the rind. A millrind or simply rind is an iron support, usually four-armed or cross-shaped, for the upper ("runner") stone in a pair of millstones.. The rind is affixed to the top of the square-section main shaft or spindle and supports the entire weight of the runner stone, which can be as much as several tons.
Modern tools for producing a Windsor chair. From bottom to top: six-degree reamer, a leg tenon cutter, an arm-stump tenon cutter, and a 1 ⁄ 2 inch (13 mm) spindle tenon cutter. The legs are splayed at angles fore-and-aft (rake) as well as side-to-side (splay) to provide actual and visual support of the person sitting.