enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Concentric reducer - Wikipedia

   en.wikipedia.org/wiki/Concentric_reducer

   A copper concentric reducer. A concentric reducer is used to join pipe sections or tube sections on the same axis. [1] The concentric reducer is cone-shaped, and is used when there is a shift in diameter between pipes. [1] For example, when a 1" pipe transitions into a 3/4" pipe and the top or bottom of the pipe doesn't need to remain level. [2]

3. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread. The taper is 1:16, meaning that for each 16 units of measurement increase in the distance from the end, the diameter increases by 1 unit of measurement.

4. British 21-inch torpedo - Wikipedia

   en.wikipedia.org/wiki/British_21-inch_torpedo

   The first British 21-inch torpedo came in two lengths, "Short" at 17 ft 10.5 in (5.45 m), and "Long" at 23 ft 1.25 in (7.04 m). ... a double reducer adapted for the ...

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

7. Rack unit - Wikipedia

   en.wikipedia.org/wiki/Rack_unit

   Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

8. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST connectors are electrical connectors manufactured to the design standards originally developed by J.S.T. Mfg. Co. (Japan Solderless Terminal). [1] JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors.

9. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13]