Search results
Results from the WOW.Com Content Network
Pulley in oil derrick A hoist using the compound pulley system yielding an advantage of 4. The single fixed pulley is installed on the hoist. The two movable pulleys (joined) are attached to the hook. One end of the rope is attached to the crane frame, another to the winch.
Swing cheek pulleys: used for light loads or redirection of forces, usually with a single pulley wheel (though multiple sheaves/cheeks are not uncommon) and an attachment point (or several) for a carabiner or sling. The cheeks are not fixed or locked in position aside from the device used to secure them to the load or rigging point.
Examples of rope and pulley systems illustrating mechanical advantage. Consider lifting a weight with rope and pulleys. A rope looped through a pulley attached to a fixed spot, e.g. a barn roof rafter, and attached to the weight is called a single pulley. It has a mechanical advantage (MA) = 1 (assuming frictionless bearings in the pulley ...
In order to determine the mechanical advantage of a block and tackle system consider the simple case of a gun tackle, which has a single mounted, or fixed, pulley and a single movable pulley. The rope is threaded around the fixed block and falls down to the moving block where it is threaded around the pulley and brought back up to be knotted to ...
The differential pulley was invented in 1854 by Thomas Aldridge Weston from King's Norton, England. [2] The pulleys were manufactured in collaboration with Richard and George Tangye. According to Richard Tangye's autobiography, the Weston differential pulley evolved from the Chinese windlass, with an endless chain replacing the finite length of ...
In sailing, a block is a single or multiple pulley. One or a number of sheaves are enclosed in an assembly between cheeks or chocks. In use, a block is fixed to the end of a line, to a spar, or to a surface. A line (rope) is reeved through the sheaves, and maybe through one or more matching blocks at some far end, to make up a tackle.
The fixed pulley on the upper shaft is driven at constant speed by a belt from the power source. The loose pulley ('idler') allows the machine to be stopped in isolation – necessary for changing speed. The stepped pulleys (left) provide three drive speeds for the machine tool (not shown), depending on which pair of pulleys is connected by the ...
The typical configuration (see diagram) uses two single pulleys and two Prusik knot loops or other suitable friction hitches. [2] These Prusiks provide fixed attachment points on the rope that can be moved when slightly loosened. The first Prusik knot is attached to the "traveling pulley," allowing it to pull on the load.